These are the 3rd variation of our Weld Washers. These are 3/8"-16 TPI
These are a little different in that they are not really meant to repair a hole. These are made to create a bolt on position for anything you need to bolt on.
Lets face it, its pretty hard to tap a .120 wall tube. And even if you do, there's just not enough material to get a strong thread. These make it easy! Just drill a 3/4" hole, drop in one of these washers and weld them up. Every Fab Shop could use 100 a week if not more!
They fit into a 3/4" drilled hole so they are good for down to about 1 1/4" tube or any flat plate. This picture shows the 3 different sizes mounted in a 1 1/2" tube.
I use these things on damn near everything. These truly are a fab'ers dream. Whether your frame building, or working on a bumper, tire carrier, or just need a bolt anchor point on your roll bars, these fit the bill with a nice ledge over hole you're about to weld up making them better than factory. Mercia!
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov. 