This is it! Finally a company making the complete kit! Several companies make parts of this but we are making the whole kit and along the way we figured out a couple of ways to make them substantially stronger. These are for an Ford 8.8 or 9" axle. The spring under bracket needs to be stronger than what we have found available, I can't tell you who made them first but I saw them 15 years ago for a Spring Under on a FJ40 Landcruiser. The problem was the Ubolts were still exposed and the sides would bend as they were first put on. We have added a bridge to "Complete" that very old design and then created the rest to go with it.

They are 1.75" deep on the bottom but take flat bottomed Ubolts so the threads can go up and not still be in the dirt and rocks. They are made 2.5" wide in the spring area, only enough to allow a snug fit so if you lose the center pin it won't fall apart on you. We make the perches slightly wider to add stability and fully rest the spring under the perch. on the integrated Ubolt Plate (It is permanently attached to the axle) we take further steps to assure a complete lockdown on the spring. The Ubolts are mounted 2 degrees inset on the upper Ubolt bracket to hold tighter down low against the springs. This is a Do It Yourself (DIY) unwelded kit and comes with the pieces to complete 1 axle left and right sides.

Available Options:
Extras:	NoneWelded (+$50.00)