This is what we have been promising for awhile, sorry for the wait. These are made for the 11.75" Bronco 5 on 5.5" rotors and an inexpensive Chevy 1/2 or 3/4 ton caliper. You can use any of the 20 or so high performance calipers that share the 7 1/32" caliper pin spacing also but the Chevy seems more than good enough for nearly everyone. These are 3/8" thick and wrap completely around the axle. If the were only partially around the axle they would be strong enough but welding the entire diameter helps control warp of the tube itself. They are available with for a 3", 3.25" or 3.5" diameter tube. These are made for Full Floating Spindle end axles but will work with the factory flanged axle ends, just cut off the bottom half of the circle. Sold in pairs.