14 Bolt Disc Brake Bracket Pair for C&C Axle
This is for converting to a standard single steel wheel minimum 15" with a maximum 4" back spacing
Here is the bracket so many of you asked us to make, it works on the Cab & Chassis 14 Bolt Axle ('73-87). This bracket uses the '75 Chevy 3/4 Ton Front rotors and
calipers just like the rest of the 14 Bolt Disc Brake brackets we make, it simply has the different offset required to run on a Cab & Chassis Axle. These make the 14 bolt Disk Brake Conversion easy! They are sold in pairs and made of 3/8" plate. They are bent and do not require spacers like the ones other companies make.
After '99 all bets are off, the newer model 14 Bolt axles have a variety of patterns & offsets, use a weld on bracket for a newer 14 Bolt axle.
*NOTE* Double check stud diameter, studs should drop freely into the rotor. DO NOT press studs into the rotor. If your hub has too large of studs you will need to drill the rotors to accept them. Be sure to have minimum 5/8" lug nut thread engagement once the wheel is installed
NAPA Part numbers for '73-'87 3/4 Ton Front, 4x4, Chevy
Calipers and Rotors:
Caliper ONLY: LH - N4674, RH - N4673 - Both of these are LATER year part numbers
OR
LH - N4597, RH - N4596 - Both of these are EARLIER year part numbers
Rotor Only - 4885677 - all years
Brake line - H86572
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov. 