Dana 70/ 70U Disc Brake Bracket Pair (Ford Dana 70)

Dana 70/ 70U Disc Brake Bracket (Ford Dana 70)

This is the bracket for your Ford Dana 70 & Dana 70U, and it actually fits! We developed these after the success of our 14 Bolt brackets and seeing what was available on the market and the problems associated with the others. The Dana 70 was used by all of the Big 3 automakers at one time or another and they all had different uses and designs specifically for them. These are for a Ford Dana 70 or Dana 70U only! These are for SRW axles, DRW axles have a different offset. Both the Dodge and GM have different flanges and tube diameters. We have actually identified 4 different flanges in use and 3 tube diameters. So Please, don't buy the 1 size fits all available out there. You may get lucky and have it work, but the odds are against you..... These also use the 73-87 Chevy 3/4 Ton Front Rotors and Calipers and those really cost peanuts but the rotor will need the throat opened by ~3/16" to fit over the back of the hub.

Note

• Requires single steel wheel 15" with a maximum 4" back spacing.
• These are not for dual rear wheels, they are made for single rear wheel axles.
• Rotor mounts on back side of the wheel hub
• Check your wheel stud diameter and length. Studs should drop freely into the rotor. DO NOT press studs into the rotor. If your hub has too large of studs you will need to drill the rotors to accept them. Be sure to have minimum 5/8" lug nut thread engagement once the wheel is installed
• Side specific, R1115-01 is the passenger side, R1115-02 is driver side
• Bend goes away from the wheel

Caliper Only:
• LH - N4674, RH - N4673 - Both of these are LATER year part numbers
OR
• LH - N4597, RH - N4596 - Both of these are EARLIER year part numbers

Rotor Only:
• 4885677 - All Years

Brake line:
• H86572