Dana 60 high-steer arms designed to work both with factory 4 stud knuckles as well as many aftermarket knuckles that feature the 5th stud. Also a springless system that replaces the stock king-pin retention spring with a threaded stud and heavy duty washer to pre-load the king-pin bushing. There is a grease fitting on the top of the pre-load stud that allows you to lubricate the bushing without any disassembly.
The arms come with tie-rod and drag link holes tapered for a GM 1 ton tie rod ends, but there is plenty of meat to drill out to 3/4" to run a Heim joint steering system as well.
For Offroad Use Only
The shoulder on some factory studs are too large for these arms. The arms are drilled to .502"
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.