Give Us a Call, We Are Ready to Help!  1-916-600-1945

Rear Bumper Tie-In Brackets For Jeep TJ/LJ

Part Number: R2605-B-Kit-1
Shipping Weight: 3.0 lb
$52.00
Shipping calculated at checkout.

Description

Rear Bumper Tie-In Brackets For Jeep TJ/LJ

Laser cut and bent from 3/16" steel. The Bumper Tie-In Brackets with added gusset to help reinforce the factory bumper mounting holes on the frame. A must have when running a heavier duty bumper with a tire carrier or recovery points to help prevent bending your rear crossmember. These come raw steel and will need to either be painted or powder coated. A single laser cut plate with two nuts welded on, easily slide in to the frame on each side to simplify installation.

  • Gusseted brackets for additional strength
  • Made to bolt on but can be welded for addition strength
  • Great addition to our LJ/TJ Rear Bumper
  • Comes with 1 pair of Brackets
  • Grade 8 Hardware included
Prop 65 Warning Icon
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

Customer Reviews

Based on 2 reviews
100%
(2)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
M
Mark Cargile
So simple

These came with the rear bumper I ordered. I have to say, these are so much easier to install than the previous ones I had! The way the nuts are welded to a steel plate makes it so simple to get the nuts up into the frame of the Jeep! And as always, the welds are perfect. Nice job guys!

J
Joel Hunt
Quality

These brackets are perfectly welded and add much needed strength to the rear crossmember and bumper.