Dana 60 Full Float Spindle
This is a pair of spindles for those of you looking to build a custom Dana 60 full-float rear end.
- Bored out for 1.5" diameter to to accept 35 spline axle shafts.
- Fits Dana 60 front and full-float rear hubs. (If you are using rear hubs you will need to use the front D60 wheel hub seal with our 2.75" diameter spindle seal surface. Napa part number NOS 27452)
- Hub must use 2" ID outer bearing and 2.25" ID inner bearing with a max bearingspread of 4.25" (seal side of inner bearing to spindle nut side of outer bearing.)
- Machined for 2.75" ID tubing (like our 3.5" x .375" wall axle tube)
- Sold as a pair.
NOTE: These spindles will work for 98 and older 14 bolt applications but will require a custom seal... use Nation Seal 476574N or Chicago Rawhide CR27526 or you can purchase through us Click Here P/N R1921.
Bearing part numbers through Timken: 382A (Race) 387AS (Bearing) and LM104911 (Race) LM104949 (Bearing)
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov. 