Lower Radius Rod RZR XP 1000 (Campbell Series)
Note: There is special editions and models that can be an exception to which bolt size you may have. Be sure to check what size radius rod bolts you have. 15mm Socket = 10mm Bolts and 18mm Socket = 12mm.
Our Lower Radius Rods are also very simple but with some serious improvements over the factory rods. The factory Radius Rods are simply too thin to add the bends needed for clearance which is a fail on both accounts. Being so thin (Ύ) they are both delicate AND dont have the clearance to avoid obstacles.
The stock Radius Rods are 3/4 Diameter X .065 Wall Mild Steel. We make our Lower Radius Rods with 1.25 Diameter .25 Wall CNC Bent 4130 Chromoly material strong enough to take the bends required to give the additional clearance. Remember that our kits give you 3 more clearance than stock and can take the hit that will eventually come. The chassis end employs a 7/8 Heat Treated Stainless Uniballs housed in a 4130 Chromoly cup to prevent roll. The wheel side uses a 5/8 Heat Treated 4130 Chromoly Rod End.
The Lower Radius Rods are more than 500% stronger than the 3/4 stock rods and they weigh in at 7lbs each so the 3.5lb weight gain versus the strength gain matters very little.
Write a review
Customers who purchased this product, also purchased:
|Lower A Arm Kit RZR XP 1000 (Campbell Series)|
|Ruffstuff Tshirt, Black|
|Upper Radius Rod RZR XP 1000 (Campbell Series)|
|Steering Kit RZR XP 1000 & 1000 Turbo (Campbell Series)|
|Radius Rod Bolt Plate XP 1000 Non-Turbo|