9.75" Shock Tower, 2" Deep - Pair
Note: Sold Unwelded
Most vehicles will fit a 10 - 12" coilover with these and no, they are not hoops! These are 9 3/4" above the frame at the shock mounting position center. They are 15 degrees offset from the frame and are 2" deep when measured from the outside face of the frame towards the engine compartment. All of our shock towers are 3/16" thick and come in pairs. These come in pairs complete with Grade 8 Nuts and Bolts.
- 3/16" thick
- 1/2" bolt hole
- Hardware included
Customers who purchased this product, also purchased:
|Paired Shock Bracket 3.0" Axle Mount|
|Paired Shock Bracket, Curved, Axle|
|2.5" Reservoir Tie Down Tab (4 Pack)|
|12" Shock Tower, 2" Deep - Pair|
|Flat Bottom Shock Tabs, Pair|
Write an online review and share your thoughts with others.