Tie Rod Offset, ES23434 TRE
NOTE: Tube adapters not included
Driver Side = Left Hand Thread
Passenger Side = Right Hand Thread
Here is the answer to the challenge of using an oversize Tie Rod without any conflict with the Diff Cover.
These Tie Rod Ends (TRE's) are offset by 1 inch, so you can move to an oversize tie rod without hitting the cover at full lock. They are also stronger being a GM 1 ton TRE. You will have to enlarge the taper but then you can easily add strength to the Tie Rod.
These are sold as Lefts & Rights and we also sell them as a complete kit with 1 1/2" X .25" wall DOM tubing. You should not match these to other TREs that are not offset so get a pair. The Taper is .749"-.748", if you are replacing a smaller TRE you will want to ream the taper to .75".
Additional Products you may need to install this product:
Click HERE for the GM taper tool
Click HERE for tapered knuckle inserts.
Click HERE for 90 degree steering stabilizer bracket
Click HERE for flat mount steering stabilizer bracket
Click HERE for a TRE 18 TPI RH tube adapter
Click HERE for a TRE 18 TPI LH tube adapter
Write a review
Customers who purchased this product, also purchased:
|7/8" x 18TPI RH Tube Adapter 1" ID HEX|
|7/8" x 18TPI LH Tube Adapter 1" ID HEX|
|TRE, Standard, TK234|
|Tapered Steering Knuckle Insert 2 Pack|
|7/8" TRE Jam Nut (18TPI) RH|