NOTE: All link brackets have 9/16" holes. If the option to choose a larger bolt size is selected, the bracket holes will need to be drilled to match. Both of the adjustable link brackets only come with 5/8" holes, and do not have options for other sizes.
adjustable upper frame bracket
- 3--RH 1.25" Heims, jams and tube adapters
- 3--LH 1.25" Heims, jams and tube adapters
- 12--High misalignment spacers
- 2-- 7/8 heims for panhard with misalignment
- 2--Panhard brackets of your choice
- 2--Lower axle 0 degree link brackets
- 2--Chassis link brackets
- 1--Upper axle link tower 10 degree
- 1--Adjustable upper link or 3 leg link (The 3 leg
link fits better on a narrow frame).
- Optional tubing
We have everything here to create a 3 link suspension, front or rear, and not low end stuff just to be cheap either! The kit is wrapped around 6 of our 1.25" Heat Treated Chromoly Heims with High Misalignment, Zinc Plated Jam nuts, and 1.5" Tube ID Weld Bungs and another set of the same in 7/8" for the Panhard. We add our Chassis Link Brackets, a 10 degree Adjustable Axle Link Tower, a 10 degree Frame bracket for the 3rd link, the Axle Lower Link brackets. We finish the Kit off with the Panhard setup, an Axle Offset panhard Bracket & the Frame panhard (inside or outside).
We now make adding the DOM tubing for your links an option, but remember that 2" x .25" wall DOM weighs - 5lbs a foot so check your prices locally before you decide to add the Link & Panhard Material(DOM)!
If you need to change anything give us a call and we can mix & match til its right for you!
Questions and Answers
Charles on -- Asked:
How road-worthy is this setup? Is this kit pretty easy to get right/set up correctly without death wobble and bump steer?
It is a do it yourself kit but when use properly with properly tuned coil overs it can handle better than a factory setup. With every build being a little bit different it is best to download a 3 link calculator to help get your bracket placement and geometry correct as the smallest changes can greatly affect the handling
Mikey on -- Asked:
Is this a direct bolt on kit or is there welding involved.
Any link conversion requires welding
Clay K. on -- Asked:
How much would this kit be if i was to just buy all of the axle/frame link mounts without the heims or link bars?
How long would the build time take to make just the link mounts?
The link mounts are usually always in stock and are listed individually under the "Link Products" in the "Suspension Products" category.