These are a coil bucket replacement for the Jeep TJ running a 3" or larger diameter tube. Our brackets are entirely .25" thick, both the plate and the tube.

Ideally you would use these for a rust belt replacement or when swapping in a new axle and want to use the stock or lift coils in the same diameter.

The surface of the pad is 6 5/8" diameter and the OD of the locator is 2 1/2" so these are perfect for the TJ but can be used with many different springs also.

They are sold in pairs and should be welded on by a competent person with the correct equipment.

Questions and Answers

Ask a Question

Name:
Email:
Question:

---

Chris C. on 8-21-2018 Asked: Do these center the spring over the axle tube, or is it offset?

Answered: These are offset at about 5/8"

---

Robert on 6-12-2018 Asked: Are the centers threaded for spring retainers?

Answered: Yes, they are threaded for a 3/4" bolt.

---

Jordan O. on 3-29-2018 Asked: I was wondering if these are the upper ones on the frame or the lower ones on the axle ?

Answered: These are the axle side buckets

---

Rob on 3-1-2018 Asked: Is this for older TJ's like a '98? Do you completely cut out the old mount or does this fit inside the round lip of the original mount?

Answered: These were originally designed for our Jeep-Ford 8.8 swap kit so the bucket is cut for the slightly larger 3 1/8-3 1/4" tube. Your tube will be a bit smaller, but I believe you will need to remove just about all of the original mount. Measured long ways on the axle tube, the ears are 6 1/8" inside width on this mount.