10 Degree Shock Brackets
These are factory replacement brackets for the Jeep TJ Dana 35 and Dana 44 rear axle. Our shock brackets are all 1/4" thick where the stock brackets are only half as thick. The net result is that ours can take a hit, not forever but a whole lot longer than the stock brackets!
This set is designed with a 10 degree kicked in angle to position your shocks towards the center of the body. They are sold in pairs and should be welded on by a competent welder with the correct equipment.
Note
- 1/4" thick
- 1/2" bolt hole
- 3 1/4" diameter tube
- 1 1/2" ID
- Sold in pairs
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov. 